Tag: gas pipe threader
In pipe threading machines, there are various visual problems which can be caused either by the engine factor itself or hard materials in the process threading Pipe Threader hire . Thus, if you are looking for a Pipe Threader hire, it is better for you to know and understand the problems so that you will be able to handle it if they actually happen to you. Some of the problems are as follows:
Flank is a leftover chip that gets stuck in the end of the threading process. It is usually a small and sharp roundabout. The way to fix it is usually to replace with a new insert and then run the threading program again. When it is good, the initial insert can be restored or re-installed.
Cheaters are the result of the use which is not perfect that it cause some waves on the thread. The cause can be that the clamp which is chocking or too hard, the finishing is too thin, or the material itself is problematic. The solution is the opposite of the cause itself.